![]() ![]() The output to the command executed as dmesg | tail is as follows : usb 1-3: new full-speed USB device number 53 using xhci_hcd Using the dmesg command i was able to check that the device has been detected properly when connected. ![]() I have tied the same on the ubuntu based computer too but the issue remain the same. To monitor the input I have tried using (Coolterm & GTKTerm), assuming an issue with the driver I have referred and tried updating the DTR line as the solutions suggested in the following stack overflow resources Reference 1, Reference 2, Reference 3. I am trying to read input from a Electronic weighing scale (Weigh sensor) connected to Ubuntu enabled UDOO board using a Prolific PL2303 serial converter cable (CA-US9), but am unable to read any input from the sensor.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |